Ecopoxy UVpoxy

Ecopoxy UVPoxy  is a UV-stable epoxy polymer for high-build clear coating small fills. We mainly use UVpoxy tofill small cracks and voids in our live edge tops.

It is safe and non-toxic.

UVPoxy offers a finish with glassy transparency, ideal for table tops, jewelry, and other applications requiring a high level of transparency. UVPoxy epoxy resits yellowing and fading. UVPoxy has virtually no odour and can be used indoors without ventilation or bulky respiration equipment.

You can purchase Ecopoxy UVpoxy in store at our Mississauga location or via our online store.

Image 1: Colsons Concepts
Image 2: Cameron DaSilva Designs
Image 3: Morgan Shaver Design

Learn More about Ecopoxy UVpoxy

Application: 

Working area should be clean & dry, and free of dust and insects. Settling dust can cause blemishes on the glossy surface.

Mixing Instructions:
In a clean, dry container; combine (by volume) 1 parts resin with 1 part hardener, and mix thoroughly for 2 minutes.

Step 1 - Seal Coat:
Brush on a thin layer to seal any pores in the surface and prevents air bubbles from forming in the following flood coats.

Step 2 - Flood Coat:
The flood coat will flow and self-level.
Foam brushes or squeegees can be used to help spread UV Poxy.
Flood coats should be applied in 1/8” layers at a time, as many as desired can be applied, however one to three coats is average for most table or bar coatings.

Minimum Re-coat Time:
This is the amount of time after the epoxy is applied in a thin film that it will arrive at a gel state, still wet, but no longer a liquid.
To re-coat without sanding between coats you must reapply after this point but before the drying time has completed.
Re-coating can usually be done within 4 to 8 hours. If re-coated within this time period no sanding is necessary between layers.
Note: If 24 hours elapsed from time of application/coating, then additional preparation is required. Lightly sand entire surface with 220 grit sandpaper until a light powdery residue appears and gloss finish has been removed to provide a profile for optimum bonding.

Work Time: 20 minutes depending on ambient temperature
Cure Time: 48 hours depending on ambient temperature, humidity and thickness. Set to touch: 4-8 hours

Technology:

UVPoxy epoxy has virtually no odour and can be used indoors without ventilation or bulky respiration equipment.
Extremely durable, scratch resilient & maintenance free
Crystal clear
UV resistant, does not yellow
High bio-content
Easy to use & low odour
100% solids
Can be poured to a thickness up to 1/4"
Ideal for countertops and table tops finishing

Sizes Available:
500ml
1L
2L
4L
8L
20L