Our NO SEAL Epoxy/Resin forms are a great investment for any shop or hobbyist looking to save time.
If you have questions about our forms please check out our FAQ's to get your answer!
Order some DIY River Sets for your next pour! We have
The Rectangle NO SEAL Molds Feature:
- 1 piece construction : (Clamps for securing your piece down not included )
- 3/8" thick
- sides of form are tapered 7 degrees out for easy release after cure
- no need for silicone in between each use.
- simply tap the form with a mallet to release the cured epoxy
- Pour up to 3" deep
- Mold Release is not necessary but can be used to prolong the life of your mold.
Rectangle Sizes Available:
15" by 5" by 2" NO SEAL HDPE Form
25" by 4.5" by 3" NO SEAL HDPE Form
18" by 10" by 3" NO SEAL HDPE Form
18" by 14" by 3" NO SEAL HDPE Form
24" by 12" by 3" NO SEAL HDPE Form
36" by 18" by 3" NO SEAL HDPE Form
48" by 24" by 3" NO SEAL HDPE Form
60" by 30" by 3" NO SEAL HDPE Form
72" by 36" by 3" NO SEAL HDPE Form
The Round NO SEAL Molds Feature:
- 1 piece construction : (Clamps for securing your piece down not included )
- 1/4" thick
- no need for silicone in between each use.
- simply tap the form with a mallet to release the cured epoxy
- Pour up to 3.25" deep
- Mold Release is not necessary but can be used to prolong the life of your mold.
Rectangle Sizes Available:
30" Diameter by 3.25" Tall NO SEAL HDPE Form
36" Diameter by 3.25" Tall NO SEAL HDPE Form
42" Diameter by 3.25" Tall NO SEAL HDPE Form
48" Diameter by 3.25" Tall NO SEAL HDPE Form
We recommend also ordering one of our Layout Templates. These templates are designed to assist in the layout process as well as the final trimming process.
Note: Putting the mold on any elevated platforms to pour causes stress on the welds which will cause them to leak. The best practice for the mold is to have it on a flat surface when pouring and curing.
