Application: 

Working area should be clean & dry, and free of dust and insects. Settling dust can cause blemishes on the glossy surface.

Mixing Instructions:
In a clean, dry container; combine (by volume) 1 parts resin with 1 part hardener, and mix thoroughly for 2 minutes.

Step 1 - Seal Coat:
Brush on a thin layer to seal any pores in the surface and prevents air bubbles from forming in the following flood coats.

Step 2 - Flood Coat:
The flood coat will flow and self-level.
Foam brushes or squeegees can be used to help spread UV Poxy.
Flood coats should be applied in 1/8” layers at a time, as many as desired can be applied, however one to three coats is average for most table or bar coatings.

Minimum Re-coat Time:
This is the amount of time after the epoxy is applied in a thin film that it will arrive at a gel state, still wet, but no longer a liquid.
To re-coat without sanding between coats you must reapply after this point but before the drying time has completed.
Re-coating can usually be done within 4 to 8 hours. If re-coated within this time period no sanding is necessary between layers.
Note: If 24 hours elapsed from time of application/coating, then additional preparation is required. Lightly sand entire surface with 220 grit sandpaper until a light powdery residue appears and gloss finish has been removed to provide a profile for optimum bonding.

Work Time: 20 minutes depending on ambient temperature
Cure Time: 48 hours depending on ambient temperature, humidity and thickness. Set to touch: 4-8 hours

Technology:

UVPoxy epoxy has virtually no odour and can be used indoors without ventilation or bulky respiration equipment.
Extremely durable, scratch resilient & maintenance free
Crystal clear
UV resistant, does not yellow
High bio-content
Easy to use & low odour
100% solids
Can be poured to a thickness up to 1/4"
Ideal for countertops and table tops finishing

Sizes Available:
500ml
1L
2L
4L
8L
20L