How to apply Rubio Monocoat Oil Plus 2C
Oil Plus 2C is a single-coat hardwax oil — one thin, well-wiped application colours and protects the wood. The whole job is about putting on a little and taking off the excess.
- Sand & clean. Sand to a final grit of about 150–180, then vacuum and remove all dust so you reach raw wood.
- Mix 3 : 1. Combine 3 parts Part A (oil) with 1 part Part B (accelerator). Only mix what you can use in 4–6 hours — after that the mix starts to cure in the cup.
- Spread thin. Work a small amount into the wood with a white pad or cloth, in zones of roughly 50–100 ft² so nothing dries ahead of you.
- Wipe off the excess. Let it react a few minutes, then remove all surplus oil with a white pad and clean shop towels within about 15 minutes per zone. The surface should feel dry, not slick.
- Cure. With Part B, handle gently after ~24 hours and allow ~5 days for full cure.
Using Precolor Easy first
Precolor Easy is an optional water-based pre-treatment for colour and contrast effects. On its own it does not protect the wood — it must be followed by Oil Plus 2C. Apply it, let it dry about 12 hours, break the raised grain and vacuum, then apply the oil with a white pad.
How much Oil Plus 2C will I actually use?
Rubio lists coverage as 300–500 ft² per litre. Where you land depends on the species, how fine you sanded, and whether the grain was water-popped — denser woods like maple sit near the top, open-grain and porous woods near the bottom. This tool positions your estimate inside that range by species and adds your buffer. For anything critical, make a sample first.
Can I use Oil Plus 2C on a cutting board?
Rubio does not recommend Oil Plus 2C for boards or butcher blocks used for cutting — a knife cuts deeper than the oil bonds. It's ideal for tabletops, furniture, cabinetry and floors.
Is it really only one coat?
Yes — Oil Plus 2C is a true monocoat. No topcoat is needed or recommended. The skill is in wiping off every bit of excess, not in adding more.
Estimates only. Coverage varies with wood species, sanding and water-popping; Rubio Monocoat publishes a range of 300–500 ft²/L for Oil Plus 2C and 150–200 ft²/L for Precolor Easy and recommends making a sample to confirm exact usage. Species estimates here are a planning guide positioned within Rubio's published range, not official per-species figures. Confirm details against Rubio Monocoat's technical data sheets before starting.